My 10 HP Chrysler Outboard wont stay in reverse gear. Fwd works great! But when I shift it into reverse, it immediately pops back out when I let go of the shift lever. It runs fine in Reverse if I hold the lever in place. It even stays in reverse gear once I am throttling at higher speeds. But at low or idle speed it pops out.
I'm thinking I need to adjust the linkage, but it isn't clearly obvious how to do that.
Anyone have experience adjusting the gear shift linkage?
Post All Outboard Topics Here
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest