Page 1 of 1
Installing a roller furling on my C-22
Posted: Sun May 16, 2004 4:43 pm
by markbeadle
Posted: Mon May 17, 2004 11:32 am
by Rich
Nice article. Do you have any pictures of your boat with the furler on? Maybe some pic's of how it's set up?
How does having a roller furler change the procedure for raising the mast, or does it?
Posted: Thu May 20, 2004 5:47 pm
by markbeadle
It does not really change the mask raising process. However it does add another dimension to check before hoisting it up in the air. Make sure you have the messenger line hooked up. Also after spending $375 on the roller-furling unit you are more protective of PVC tape, it kinda flops around as you are raising. If you look at the above diagram on part G, this is where you connect the end of the stay to the boat and part B, the spool raises to access the turnbuckle for tightening. Then the spool is held down by pin C.
I will take some pictures the next time I go out.
Posted: Fri May 28, 2004 10:44 am
by Rich
Do you have to get a new sail for the roller furler or can you use the regular Genoa and retro fit it somehow?
Posted: Sun Jun 20, 2004 8:08 pm
by markbeadle
Posted: Sun Jun 20, 2004 8:15 pm
by markbeadle
Posted: Sat Jun 04, 2005 5:45 am
by markbeadle
I fixed the links to the pictures.