Here you can discuss Chrysler Sailing across all makes of Chrysler sailboats.
EZFEED
Posts: 28 Joined: Sat May 04, 2013 4:23 pm
Location: Lafayette, LA
Post
by EZFEED » Wed Jul 24, 2013 5:02 pm
astrorad
Posts: 730 Joined: Fri Feb 19, 2010 8:09 pm
Location: s.e Wisconsin
Post
by astrorad » Wed Jul 24, 2013 6:04 pm
Raise a glass to the man who raised his mast!!! Well Done Matey!!!
Bill
CaptainScott
Site Admin
Posts: 3111 Joined: Wed Sep 24, 2008 10:46 am
Location: Washington State
Contact:
Post
by CaptainScott » Wed Jul 24, 2013 6:56 pm
I'll tip my glass!
Congratulations!
Scott
Chrysler20%26
Posts: 836 Joined: Mon May 01, 2006 10:28 pm
Location: Pinconning Michigan
Contact:
Post
by Chrysler20%26 » Wed Jul 24, 2013 11:25 pm
Looks good, an I will drink to that too. Good job
EZFEED
Posts: 28 Joined: Sat May 04, 2013 4:23 pm
Location: Lafayette, LA
Post
by EZFEED » Thu Jul 25, 2013 2:55 am
Got a question....
Spreader bar ends and the little wheels that are found above them. How important are they?
Should I just get some leather or vinyl and make my own?
EmergencyExit
Site Admin
Posts: 2956 Joined: Wed Dec 10, 2003 5:02 pm
Location: Mississippi Gulf Coast
Post
by EmergencyExit » Thu Jul 25, 2013 3:40 am
Keeps jib/genny from rubbing/snagging on shroud there..never looked terribly effective..
EZFEED
Posts: 28 Joined: Sat May 04, 2013 4:23 pm
Location: Lafayette, LA
Post
by EZFEED » Thu Jul 25, 2013 6:41 pm
I think I'll make some wheels out of plywood and dip them in resin then make some boots out of vinyl.