Page 1 of 1

C22 Rudder Pieces

Posted: Sat Jun 10, 2017 7:07 am
by mrichey
In this document on page 333-10:

http://captainscottsailing.com/Chrysler ... Detail.pdf

There are two pieces not shown, 91C and 91D the bushing and sleeve. Does any one have a picture of those pieces? Or a diagram? Crude sketch? Anyone have a place to buy replacements for them?

Posted: Tue Jun 13, 2017 5:21 am
by EmergencyExit
Looking at the diagram nothing seems to be missing. There is a bolt and sleeve around it inside the tube/cheeks where the tube meets the cheek - that's what the rudder up pull line goes around. Perhaps that's it. Or its that Rudder stop kit that's also not shown

In case you haven't seen in there are some helpful diagrams on Windward's site at

http://chryslersailing.lizards.net/sail_rudder.html

Posted: Tue Jun 13, 2017 4:48 pm
by mrichey
I think it is the bolt and sleeve that I'm missing. No dimensions for the bolt or sleeve in the diagrams that I can see. Any one have those?

Posted: Thu Jun 15, 2017 5:19 am
by EmergencyExit
mrichey wrote:I think it is the bolt and sleeve that I'm missing. No dimensions for the bolt or sleeve in the diagrams that I can see. Any one have those?
I checked my C26 and I thinks its about the same as a C22. Bolts is a 1/4"x2". Space in between checks is 1 1/2".

The sleeve over the bolt is whatever you come up with that fits...It really doesn't work very good anyway honestly..always a chore to pull the rudder down..

Posted: Thu Jun 15, 2017 7:00 pm
by mrichey
Thank you!