Salon table
Posted: Fri Jun 30, 2017 7:38 pm
Well, I am wrapping up almost 7 years of re-building my TMI 22' and am almost ready to sell her.
Over this last winter I made a nice replacement table in the salon and that was going to be the end of the table project. Until this spring when I really committed to selling. I recently decided to fit the table so the new owner can use it as such, if desired.
I have a dumb question because I absolutely cannot find any photos of C22 cabins. it appears to me that the table, when raised, rests against the port hull interior; and a beefy pipe leg into the top and bottom brackets is all that holds it up.
Is that true? If so, Do they work well that way? It seems to me that it would be a sturdier table if I make something in the hull to support the port side of the table.
Thanks
Over this last winter I made a nice replacement table in the salon and that was going to be the end of the table project. Until this spring when I really committed to selling. I recently decided to fit the table so the new owner can use it as such, if desired.
I have a dumb question because I absolutely cannot find any photos of C22 cabins. it appears to me that the table, when raised, rests against the port hull interior; and a beefy pipe leg into the top and bottom brackets is all that holds it up.
Is that true? If so, Do they work well that way? It seems to me that it would be a sturdier table if I make something in the hull to support the port side of the table.
Thanks