Page 1 of 1

Rebuilding my 1979 Chrysler

Posted: Sat May 09, 2015 4:21 pm
by michigansailor
Hey Guys, I am rebuilding my 26' Chrysler and need a new rudder shaft bearing for my boat. I took my rudder apart and found that mine is broken and has been repaired once already. I am not sure if anyone knows where I could get one or how to make something that will fit.

Thanks I would love to get it fixed so I could put it in the water this summer.

Thanks Michigan Sailor

Posted: Sat May 09, 2015 6:21 pm
by CaptainScott
Welcome to the forum Michigan sailor!
You might want to post this in the general discussion as most folks do not visit this discussion area much!

Again,
WELCOME!

Scott

Re: Rebuilding my 1979 Chrysler

Posted: Fri May 04, 2018 1:20 pm
by Skipper Dan
I think you can get them at rudder craft very well made I did mine