New carpet for bunks on the C22 trailer

Here you can discuss Chrysler Sailing across all makes of Chrysler sailboats.
Post Reply
User avatar
Capt. Bondo
Posts: 713
Joined: Thu Aug 20, 2009 8:08 am
Location: Hudson, WI

New carpet for bunks on the C22 trailer

Post by Capt. Bondo »

I'm looking to replace the rotted green astro turf :roll: on my trailer bunks.
The bunks are 12' (144") 2x6's.
Looking around I finding that most standard bunk carpet to cover 2x4's.

1. What have folks been using to cover there bunks?
2. Does the commercial bunk carpet sold to cover a 144" bunk give you extra to wrap around the ends?
3. Where is a good recource to obtain carpet, I'd like to get blue to accent the boat trim.

Thanks
H:)ppy Place
78 Chrysler 22

You can go to a Zen Master or you can go Sailing, either way you end up in about the same place..... a Happy Place
User avatar
Banshi
Posts: 689
Joined: Wed Jul 04, 2007 10:10 am
Location: Jacksonville, FL
Contact:

Post by Banshi »

Got mine here, I am sure many places sell it and I am not sure regular indoor outdoor carpet would not be just as good..........my bunks are 2X6

http://shop.trailersailor.com/detail.ht ... 0&cat=3210
User avatar
Jmckamey
Posts: 336
Joined: Tue Nov 17, 2009 12:53 pm
Location: East TN

Post by Jmckamey »

Last time I recovered bunks I used carpet reminants from a local carpet store. Lowes sells some nice looking outdoor carpet. It comes in blue and gray. Trunk carpet works good too.
skyking

Post by skyking »

I used indoor /outdoor on mine and a few other boat trailers that we had...never had any problems, and you can have it cut to whatever length you need...
User avatar
clair hofmann
Posts: 221
Joined: Sun Apr 10, 2005 6:20 pm
Location: S.E.Pa / Inner banks NC

Post by clair hofmann »

Forget the carpet! When my carpet went bad on my Venture trailers I replaced it with UHMW. It will be permanent and the boat slides on and off the trailer easier. I used 3/8" thick by 6" wide and through bolted it to the bunk. I countersunk the material and used 1/4" stainless flathead screws with washers and nylock nuts.

I got the UHMW from Mcmaster. It comes in 6'lengths.
Clair
skyking

Post by skyking »

Cliar, I like that ...

do you have any pictures???
Post Reply