Center board gasket replacement

[turfdog]

The center board gasket on the Mutineer I have needs replacing and looking for suggestions as to what material to use and where I can get it.

[Mario G]

Can you post a picture of the old one? There are automotive seals of all kinds .

[EmergencyExit]

Seen some Coronado C15 types use the garage door bottom seal material. I think the factory replacement material for those boats is sailcloth over mylar.

[turfdog]

There are two different types of gasket rubber on it now and it looks like garage door material but the mylar material sounds like a better idea. Any thoughts on where I can get this?

[Guster]

I replaced mine with this, (3" wide)

http://www.apsltd.com/c-100-SlotStrip-C ... erial.aspx

And followed Ray's instructions here,

http://www.mutineer15.org/Rey_s_Upgrades.html

Just open the .pdf CB gasket replacement.

Good luck,

Dan

[EmergencyExit]

The thread I was looking at mentioned Ullman Sails as a source, but you probably could Google a better source that would be less costly.

If you haven't found it here's an article on replacing that gasket

http://www.mutineer15.org/files/37061448.pdf

[turfdog]

Thanks to all for the help. The link for the material is exactly what I was looking for. This forum is the best. Will have to post a picture once I am done.

Greg